Hose Adapter. Connect your pole to pure water.
Use this guide to connect your water fed pole to your Spot Free Rinse tank or garden tap using the 8mm push fit hose adapter with flow control.

The three ends of the adapter
One small fitting, three jobs.
- 8mm push fit connector: grips standard water fed pole hose.
- On/off ball valve: set the flow at your fingertips instead of walking back to the tap.
- Standard garden hose end: male fitting that clicks into your Spot Free Rinse tank outlet or garden hose.
Connecting it up
From tank to pole in under a minute.
Connect the garden hose end
Tank or tap
- Click the adapter's garden hose end into the hose coming from your Spot Free Rinse tank's OUT connector (for purified water), or straight onto a garden hose.
Push in the pole hose
8mm push fit
- Cut the end of your pole hose square and clean.
- Push the 8mm hose firmly into the push fit collar until it seats.
- Give it a gentle tug to confirm it's locked in.
Set your flow
Control at your fingertips
- Turn the tap on, then open the valve half or a quarter of the way. It's a ball valve, and a quarter turn opens it fully, so only open it part of the way.
- The six brass jets put out a lot of water, so half or a quarter open is plenty. While you scrub, you only need the glass wet with water running down it to carry the dirt off. Turn it up or down as you need, then give it a good rinse at the end. Too much water splashes up above the window and washes down dirt and chalky old paint from above, which dries on the glass and won't dry clear. It also uses up your resin faster for no better result.
- On our 22ft and 30ft pole kits there's a second ball valve just before the brush. Open that one fully and set the flow here at the handle.
- Check the connections for leaks before you start.
Tips & care
Keep it leak-free for years.
Helpful tips
Best practice
- If the push fit weeps, pull the hose out, re-cut the end square, and push it back in. A ragged hose end is the usual cause of drips.
- Close the valve while moving between windows or panels to save purified water.
- Rinse the adapter with fresh water and store it out of the sun when you're done.
Hose adapter questions
Quick answers before you connect up.
Will it fit my water fed pole hose?
If your pole uses standard 8mm hose, which most water fed poles do, including our 22ft and 30ft Hybrid Kits, it pushes straight into the push fit collar. Cut the hose end square first so the collar can grip and seal properly.
Can I connect it straight to a garden tap?
Yes. The male garden hose end clicks into standard Australian hose fittings, so it connects to a garden hose or tap directly. For spot-free work, connect it to the hose running from your Spot Free Rinse tank's OUT side instead, so purified water reaches the pole.
Why does it have a flow control valve?
So you can stop, start and set the water at your fingertips instead of walking back to the tap. Keep it half or a quarter open while you scrub. Too much water splashes dirt and chalky old paint down from above the window, and it uses up your resin faster for no better result.







